Full access allows:
- Solve all tests online without limits;
- Remove all advertisements on website;
- Adding questions to favorite list;
- Save learning progress;
- Save results of practice exams;
- Watching all wrong answered questions.
- Homepage »
- Chief Engineer (Steam-Motor-Gas Turbine Plants (Limited)) »
- Q604 - Electrical, Electronic, & Control Engineering
125. What problem with a printed circuit board may resolve itself once a board is removed from its edge card connector and then reinstalled?
Reseating a circuit board can temporarily resolve issues with corroded pin connectors because the motion can scrape away light corrosion and restore contact; this is a contact problem, not a repair of internal board damage, and the fault will reappear if the corrosion isn't addressed.
Comments (0)
There are no comments at the moment. If you found an error or think question is incorrect, tell everyone about it
Only signed in users can write comments
Signin