Full access allows:
- Solve all tests online without limits;
- Remove all advertisements on website;
- Adding questions to favorite list;
- Save learning progress;
- Save results of practice exams;
- Watching all wrong answered questions.
- Homepage »
- First Assistant Engineer (Steam-Motor-Gas Turbine Plants (Unlimited)) »
- Q511 - General Subjects I
2. Which of the tolerances listed is allowed on the outside diameter of the bushing illustrated
The correct tolerance for the outside diameter is 0.0005 inch, calculated as the difference between the maximum (1.6015 inch) and minimum (1.6010 inch) limits specified in the drawing.
Comments (0)
There are no comments at the moment. If you found an error or think question is incorrect, tell everyone about it
Only signed in users can write comments
Signin