Full access allows:
- Solve all tests online without limits;
- Remove all advertisements on website;
- Adding questions to favorite list;
- Save learning progress;
- Save results of practice exams;
- Watching all wrong answered questions.
- Homepage »
- First Assistant Engineer (Steam-Motor-Gas Turbine Plants (Unlimited)) »
- Q517 - Electrical, Electronic, & Control Engineering
37. To properly use a clamp-on type ammeter to check current flow, what must be done FIRST?
The initial step in using a clamp-on ammeter is to position the jaws around a single insulated conductor to measure current via magnetic field sensing; this method does not require circuit interruption or test lead calibration.
Comments (0)
There are no comments at the moment. If you found an error or think question is incorrect, tell everyone about it
Only signed in users can write comments
Signin