Full access allows:
- Solve all tests online without limits;
- Remove all advertisements on website;
- Adding questions to favorite list;
- Save learning progress;
- Save results of practice exams;
- Watching all wrong answered questions.
- Homepage »
- Third Assistant Engineer (Steam-Motor-Gas Turbine Plants (Unlimited)) »
- Q538 - Steam Plants II
274. The original bridge gauge reading for a reduction gear bearing was measured as 0.008 inches. A year later, the bridge gauge reading for the same bearing is 0.010 inches. What would this indicate?
The increase in the bridge gauge reading indicates bearing wear equal to the difference between the new and original readings; therefore, bearing wear is 0.002 inch.
Comments (0)
There are no comments at the moment. If you found an error or think question is incorrect, tell everyone about it
Only signed in users can write comments
Signin