33. To make the pieces shown as «A» in the illustration a locational interference fit, what will be necessary

the piece with the hole must be heated until the inside diameter of the hole is .245 inches +/-.001
do nothing, this is a close sliding fit but there is no way to make it a locational interference fit and a close sliding fit is an acceptable alternative
an interference is not possible unless you turn down a new shaft with a diameter of .250 inches +.001/-.000
hone the shaft until the roughness value is 50 micro inches (.005 inch clearance)

Comments (0)

There are no comments at the moment. If you found an error or think question is incorrect, tell everyone about it

Progress: 24% (23/94)?

Learning progress ?

2/178